• Salesman
  • Gearmotor Chat Viber
  • Salesman
  • Electric motor Chat Viber
  • Salesman
  • AC Motor Chat Viber
  • Salesman
  • Worm gear motor Chat Viber
  • Salesman

Featuring ac motor products

Sunday - 01/09/2013 12:07
Featuring its high quality and excellent performance helical gear reducer manufacturer gear reducer is one of DOLIN main products.
Featuring ac motor products
Check oiling case first determine whether there is oil and keep oil at more than half of the oil level gauge Installed in ventilated temperature 0 C ~ 40 C environment unplug refuel before using the cover latch
Turbine reducer connection coupling link into force or the output shaft the need to also make two really fixed axis parallel to the positive locking base
When the input shaft is hollow adding the appropriate grease to avoid excessive wear and aperture issue abnormal sound the shaft can be coated with anti-rust paint to avoid rust sprocket connected to the output shaft of the pulley with H7 tolerance must be used to avoid sending a different sound to the shaft surface damage Turbine gear lubricant Should be injected into the turbine gear
Before running lubricating oil to the top of the center mark After the first 100 hours of use internal wash put new oil after an oil change once every 2500 hours
Insufficient grease may cause rapid wear and reduce the efficiency of the turbine too much may lead to leakage
Lubricating oil to the top of the center can be marked Matters turbine installation gearhead turbine gear installed to take into account its axis poles and other factors turbine reducer points single-stage two-stage
Most of the reducer output shaft and the input shaft has but there are a small part of the hollow shaft such as the most common bakdo turbine is hollow shaft gear type
Another case is that there is an input shaft but no gear output shaft such bako turbine reducer
Of course depends on the user's specific needs may be turbine gearbox input shaft and the motor is recommended when using elastic coupling link while the output gear coupling is used along as well as other non-rigid coupling
Enter the output axis and the axis of the axis of the coupling part must be kept concentricity the error does not exceed the rating of the coupling range used
After a good grasp of these cases the next is the degree of operating flexibility to detect reducer detection method is very simple to rotate by hand several times repeated must be ,ac motor

Total notes of this article: 9890 in 2110 rating

Click on stars to rate this article

  Reader Comments

Security Code